Electrical Fittings & Fixtures Maintenance
Fault finding, rewiring, lighting and distribution board work.
What we get called out for
A breaker that trips whenever a specific appliance runs
Lights dimming when the AC starts
Sockets that feel warm to the touch
A burning smell near the distribution board
Flickering downlights on one circuit
An RCD that will not reset
The same sequence on every visit
Nothing starts until you have approved the price. If the survey shows the problem is smaller than expected, we say so and revise the quote.
-
01
Isolate safely and confirm dead before touching anything
-
02
Test insulation resistance and earth continuity
-
03
Trace the fault to a circuit rather than guessing
-
04
Replace the failed component with a correctly rated part
-
05
Re-test the circuit under load
-
06
Label the distribution board properly before leaving
The symptom is not the fault
- Circuits loaded beyond their design
- Loose terminations that have worked free with heat cycling
- Moisture reaching an outdoor fitting
- A neutral fault shared across circuits
- Cheap fittings that were never rated for continuous load
- Earthing that was never properly bonded
What we actually fit
Choose your community
Each community has its own page explaining what we expect to find in its buildings specifically.
Sharjah · 26
Ajman · 18
Dubai · 102
Book a visit
Tell us what needs doing. We confirm a time, survey the property, and give you a fixed price before any work starts.